Tools - Articles - Page 8 | Roofing Contractor

Spider Tool Holster

February 13, 2020

Keep tools safe and at-the-ready with the Spider Tool Holster, made so that any tool can be easily switched from a belt-mounted tool holster to a table mounted tool dock in seconds.

New Control Series Tape Measures from Crescent Lufkin® Merge Quality with Innovation

December 16, 2019

No Comments

By combining innovation and quality, Crescent Lufkin has raised the expectations for what something should have always been. In this case, it's redefining the quintessential tape measure.

Tool Belts and Harnesses: Over, Under or Integral?

Roofing contractors must carefully consider how to use a harness and tool belt together in order to exhibit a good-faith effort to eliminate or mitigate infeasibility and greater fall hazards.

Chip Macdonald

October 25, 2019

No Comments

Except for the roofing inspector, most roofing contractors would expect their employees to wear a tool belt while on the roof deck.

Ex6 Layout Squares with Two-in-One Design Lead New Product Line from Crescent

October 22, 2019

No Comments

This new layout square from Crescent gives roofing contractors the benefit of two tools in one, providing accurate measurements as both a 7-inch and 12-inch square.

Malco Products, SBC Donates $25,600 to SkillsUSA Students

August 8, 2019

No Comments

Malco's donation of Backpack Tool Kits supported students competing at the SkillsUSA National Leadership and Skills Conference in Louisville, Ky.

Werner Introduces Multi-Position Fiberglass Pro Ladder

October 17, 2018

No Comments

Werner has introduced the Multi-Position Fiberglass Pro Ladder.

New Additions, Upgrades to FLIR Premiere Handheld HD Cameras

October 10, 2018

No Comments

FLIR Systems Inc. has released the FLIR T1010 — a new addition to the T1K series of HD thermal imaging cameras.

DeWalt Announces 23Ga. 2-inch Pin Nailer

August 9, 2018

No Comments

DeWalt announces the new 23Ga. Pin Nailer, a product designed to address common user frustrations associated with 23Ga. pin nailers.

Ergodyne Delivers Tool Tethering Simplicity with Squids Hand Tool Slips

July 1, 2018

No Comments

Ergodyne has announced an addition to its line of pioneering one-step attachment points meant to simplify the challenging process of tethering power tools, hand tools and instrumentation.

Bosch BLAZE Outdoor GLM400C Connected Laser Measure with Viewfinder and Bosch BLAZE Outdoor GLM400CL Connected Laser Measure with Camera

June 25, 2018

No Comments

The Bosch Group has added two new lasers in the Bosch BLAZE lineup — Bosch BLAZE Outdoor GLM400C Connected Laser Measure with viewfinder, and Bosch BLAZE Outdoor GLM400CL Connected Laser Measure with camera.